About matching of Starboard Foil 122 and alumi GT
Starboard Foil 122とalumi GTのマッチングについて
Starboard の Foil122はロッカーとキックがあるので、フォイルを取り付けたときボードとフュースレイジが平行にならず、ウイングの迎え角が足らない、ように思います。このようなとき一般には、水平尾翼の角度調整機能でトリムできるのだけど、それが付いていません。そこで、マストの取付角度を調整することにして、くさび型ゴムを作り、ボードとフランジの間に挟み取り付けました。その結果、ボードとフュースレイジが平行になり、ウイングの迎え角が2度くらいになったので、ボードが走り出すとテールに加重しなくてもフラットに浮き上がり、風が弱まったときもフラットに着水するようになりました。特に微風時に軽く浮き上がりよく飛ぶようになりました。
Because Starboard's Foil 122 has a locker and a kick, I think that the board and fuselage do not become parallel when attaching the foil, and the angle of attack of the wing is not enough.In such a case, in general, you can trim with the angle adjustment function of the horizontal stabilizer, but it is not attached.So, I decided to adjust the mounting angle of the mast. I made a wedge type rubber and pinched it between the board and the flange.As a result, the board and the fuselage became parallel, and the angle of attack of the wing became about 2 degrees so that as the board ran, it rise flat even without weighting on the tail, even when wind weakens, I began to do.Especially when it is light wind, it flew well in this setting.
YouTube => https://www.youtube.com/watch?v=4h3uvCZbNVA&t=305s
ノーマルセッティング, Genuine specification
クサビ型のゴム板2本のサイズは、長さ230mm x 幅16mm、後側の厚みを9mm。タトル・ヘッドの左右のフランジの上に配置してタトルのネジ2本で締め付けて固定した。The size of two wedge-shaped rubber plates is 230 mm in length x 16 mm in width and 9 mm in thickness on the back side. It was placed on the left and right flanges of the turtle head and tightened with two turtle screws and fixed.
クサビ型のゴム板2本後9mm厚をセットするとこうなります。When wedge is attached.
ちなみに、NaishのフォイルはテールロッカーのあるNaishのフォイル用ボードにマッチするように作ってあったので、このFoil 122にもぴったり合うと想像していたので試したところ、まさにジャストフィットしているように見受けられます(まだ乗っていませんが)By the way, I imagined that Naish foil fits this Foil 122 as it seems to have been made to match Naish's foil board with tail locker. I just tried installing it, but it seems that it is exactly right. (Although it is not on the sea yet)
では、Starboard Alumi Foilが他と違っているのかを見るため、NOBUWORKSに取り付けるとこうなります。このセッティングでよく乗っていますが、とても乗り易いです。So, in order to see if Starboard Alumi Foil is different from others, I installed it in NOBUWORKS. I ride a lot with this setting, but it is very easy to get on.